Feel Safer in Your Bathroom by Installing Grab Bars for a Shower Wall

The shower could be a very scary place when dozens of soap suds start to accumulate on a lawn of one's shower. One method to feel safer inside shower is usually to use a grab bar towards the wall. Listed below are the various tools you will need and directions to correctly put in a grab bar with your tiled bathroom shower.

When you have acquired a grab bar you need to collect the equipment was required to handle the installation. Listed below are the knowhow you'll need:

Philips-head screwdriver
Drill
1/8 inch masonry bit or glass and tile bit
Stud finder or perhaps a amount of wire
Tape-measure
Silicone caulk
Sharp awl or carbide glass and tile drill bit
Wood bit, 1/16 narrower compared to sized mounting screws

Firstly , you have got to do to install your grab bar is to learn a wall stud.  If you can get a stud finder this will assist greatly.  Run the stud finder down the wall until a wall stud is located and mark the spot with a fine point marker.  If you don't have a digital stud finder, donrrrt worry, you need to take a single/8 masonry bit or glass and tile bit and drill an opening into the grout.  Then take your amount of wire making a bend from it.  Place the wire from the hole and by spinning it everywhere you look it is best to hit a stud.  If you cannot get a stud, the outlet that you just drilled can be stuffed with a small amount of silicone caulk.  Always flatten the dab of silicone caulk so that it doesn't protrude in the grout line, enable the caulk to dry for about three hours.  If you could have powdered grout handy, jumble a lttle bit and patch the hole.  Re-drill another hole and soon you find a stud.  When you do find a stud, measure 16 inches from that hole and you ought to manage to drill into another stud.

You really need to mark your stud locations so that you can measure from your lower tub to look for the keeping your bar.  Place your bar making sure that both sides has expired a stud and mark the screw holes which might be from the mounting bracket.

To drill the mounting holes into tile you will need to produce a starting place for the drilling bit normally the part will run across the tile.  To create a beginning use a sharp awl or afore mentioned drilling bit.  With your hand, twist the instrument on your own make to create a slight impression for the tile; this will likely maintain your drill bit from slipping.  Avoid a punch or perhaps you will probably crack your tile.  Use the glass and tile bit to drill your hole.  If using a masonry bit, place tape above the tile and drill slowly to avoid shattering the tile.  You don’t need to break your tiles when screwing the mounting brackets on either so make use of a bit that's 1/32 wider as opposed to sized the mounting screw you'll be using.  Start drilling the outlet slowly and with even pressure so they won't slide off your mark.  Use light pressure when drilling to avoid cracking the tile.

Make certain to not drill deeper versus the tile and it also backing. At this time, you have got to change your bit to the wood bit 1/16 narrower as opposed to screw.  This makes a pilot hole inside the studs.

The ultimate step should be to mount the bar.  Silicone caulk will have to be put on the holes before mounting; this can be to protect the wood and backing boards behind the tiles from leaking water.  Simply screw the bar towards the wall.  You'll want to use metal screw or they will rust.  Tighten the screws firmly making sure never to over tighten them or they will crack the tile.

You ought to have your grab bar properly installed.  Anyone can take a peaceful, relaxing shower and feel safer at the same time.